How to setup the YN8370 N300 Wi-Fi Range Extender

The YN8370 N300 Wi-Fi Range Extender is ideal for boosting your existing ISP modem/router's Wi-Fi to a nearby room, and also provides a cabled network port at the remote location for non-Wi-Fi devices.

Connecting to your existing modem/router via Wi-Fi

1. Set the bottom MODE switch on the side of the extender to the middle REPEATER position
2. Plug the extender into a power point next to your internet modem / router
3. Switch the power on, move the side power switch on the extender to ON, and wait 30 seconds.
4. Press the round WPS button on the front of the extender for 6 seconds
5. The WPS/Power LED will start flashing when you release the button
6. On your internet modem / router, and press and hold the WPS button for 2-3 seconds. 
7. Wait 30 seconds for the units to find each other
8. The LEDs will go out, then the WLAN LED will blink for a few seconds, and go solid when done
9. Unplug the extender and plug it in at the location that you want to extend to

On your Wi-Fi devices, search for a new Wi-Fi named (your modem/router's Wi-Fi name)_EXT and connect to it. The extender's Wi-Fi will use the same password as your internet modem / router's Wi-Fi.

You can also plug in a wired network device to the LAN port on the extender using a patch cable - it will connect automatically.

Note that the room you want to extend to still needs to have *some* Wi-Fi signal available from your ISP modem / router, for the extender to work with - you can check if the ISP modem/router Wi-Fi signal is in that room by connecting to it with your phone. If the phone can't connect to the ISP modem/router's Wi-Fi, you may have to place the extender closer to the ISP modem/router.